FLEX update!

Connect your Flex to the ECU connector to access the whole content of Internal Flash and Internal EEPROM memories, then start working: you will optimize performances of vehicles such as Defender and Range Rover or remove trouble codes from Bosch MD1CP007.

Some of the supported vehicles:

  • Land Rover Defender L663 3.0L MHEV 203PS Hybrid
  • Land Rover Defender L663 3.0L MHEV 304PS Hybrid
  • Land Rover Range Rover L460 3.0L MHEV 253PS Hybrid
  • Land Rover Range Rover L460 3.0L MHEV 304PS Hybrid

This new protocol is available for the following software packages:

Bench

  • FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
  • FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
  • FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
  • FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
  • FLS0.5M – SW Flex Full Master
  • FLS0.5M – SW Flex Full Slave

Newly added protocols:

(Bench)

  • JLR Bosch MD1CP007 TC298 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM

 Reading Time: ~ 1 minutes and 30 seconds Writing Time: ~ 1 minutes  

Bug Fix:

  • Added new CRC type for PSA Continental SID80x  
  • Added new CRC type for VAG Bosch MD1CS004  
  • Added new CRC type for FCA Marelli MM10JA  
  • Added new CRC type for Mercedes Continental ACM2.1 D3  

Software Improvements:

  • Improved identification process on FCA Continental GPEC2  

FLEX Master
FLEX Slave