17 Oct.’ 2023
FLEX Updates!
This batch of new protocols allows you to work on any kind of ECU, regardless its year of production, therefore you will be able to program in OBD even ECUs created after July 2020 (currently not supported in Bench):
- MD1CP004
- MD1CP014
- MD1CS004*
- MG1CS002
- MG1CS008
- MG1CS001
- MG1CS011
- MG1CS111
*Some hardware versions excluded
Please note: if the virtual read is not available, the unlock procedure is not supported
Some of the supported vehicles:
- Audi A1 1.0L TFSI 95PS
- Audi A3 1.5L TFSI 150PS
- Audi Q3 2.0L TFSI 230PS
- Skoda Kodiaq 2.0L TSI 180PS
- Volkswagen Passat 2.0L TFSI 190PS
- Seat Leon 2.0L TSI 190PS
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
(OBD)
- VAG Bosch MG1CS001 SPC5777 Read/Write/Checksum Calculation Maps, Read/Write/Checksum Calculation Maps & Code
- VAG Bosch MG1CS011 SPC5777 Read/Write/Checksum Calculation Maps, Read/Write/Checksum Calculation Maps & Code
- VAG Bosch MG1CS111 SPC5777 Read/Write/Checksum Calculation Maps, Read/Write/Checksum Calculation Maps & Code
Writing Time: ~ 2 minutes
Bug Fix
- Added new CRC type for Mercedes Continental ACM2.1
- Added new CRC type for Hino Denso SH72543
- Added new CRC type for Kia/Hyundai Kefico CPEGD2.20.3
- Added new CRC type for Mercedes Siemens SIM266
