Flashers

Autotuner is a universal tool able to read information from most ECUs and microcontrollers available on the market in boot Tricore Infineon (BSL) or via the OBD diagnostic socket. It is delivered with all the required accessories for both BSL and OBD in a dedicated package. More than 3500 control units is supported at this moment!

Autotuner is a universal tool able to read information from most ECUs and microcontrollers available on the market in boot Tricore Infineon (BSL) or via the OBD diagnostic socket. It is delivered with all the required accessories for both BSL and OBD in a dedicated package. More than 3500 control units is supported at this moment!

Toyota Flasher, a joint project by Autokey and PCMflash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed in TOYOTA, LEXUS and SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world.

KESS3 is the new Alientech ECU and TCU Programmer via OBD, Bench and Boot Mode all in a single tool.

KESSv2 Slave is a ECU and TCU, the best tool to write back the original or modified file in the vehicle ECU in a few minutes, simply communicating through the OBD port. Through an OBD standard port, or a dedicated connector, KESSv2 can be connected to cars, motorbikes, trucks, tractors and boats to read and write the parameters of the engine or of the transmission. The goal is to maximise the performance of the vehicle and of the electronic control unit, facing problems that a standard diagnostics cannot solve.

MPVI3 by HP Tuners, the fastest and most sophisticated OBDII interface device to date.

MultiFlasher is a chip-tuning solution intended for reading/writing FLASH and EEPROM memory of ECUs. It can use any adapter supporting J2534 standard, e.g. OpenPort 2.0 by Tactrix. Before flashing and after reading the program checks the firmware and checksums, and corrects them if needed. It allows to avoid flashing incorrect dumps or to make sure that reading is correct. It contains a function of errors reading, decoding and reset with a possibility to manually add and edit their description.

FLEX, a new solution by Magicmotorsport, has been released to replace the famous MAGPro x17. It is a modular solution which allows you to choose only the protocols you need. 

FLEX, a new solution by Magicmotorsport, has been released to replace the famous MAGPro x17. It is a modular solution which allows you to choose only the protocols you need. 

K-TAG Master is a professional universal bench programmer for ECUs and TCUs of cars, motorcycles, trucks, agricultural machinery and boats.